Hot melt glue for direct mail: fugitive vs permanent, and keeping a glue system running

By the Tri-State Equipment parts desk. Updated November 16, 2026.

Hot melt is the quiet workhorse of a mail shop. Every tip-on card, every sealed self-mailer flap and every insert that stays put on the page got there with a dot or a bead of glue. Two kinds do almost all of it.

In short

  • Fugitive glue holds cards, samples and inserts in place and peels off cleanly; permanent glue is for closing and tipping.
  • The two failures we see most are char (glue cooked dark in the tank) and stringing or missing dots.
  • Keep the lid closed, run the temperature the glue’s data sheet calls for and no higher, and treat nozzles, heaters and filters as consumables.
  • Order by glue type and the melt system it runs in.

Fugitive (removable) glue

Low tack by design. It holds a card, a magnet, a coin or a sample on the carrier, survives the inserter and the mail stream, and then peels off in the reader’s hand without tearing the paper. Applied as small dots from a tip-on or attaching line. If the dot is too big or too hot it bonds permanently, so the dot size and temperature matter more than they do with permanent glue.

Permanent glue

Standard hot melt for closing and holding: sealing a self-mailer flap, tipping a reply card so it stays, spot gluing a folded piece in place of tabs where USPS allows it, and carton closing on the packaging side. Applied as dots or a continuous bead from a gun or spray head on the folder, inserter or conveyor.

How it gets on the piece

An inline glue system has a heated tank that melts pellets or chips, a hose that keeps the glue hot on the way to the head, and a gun or head that fires dots or beads on a signal from a photo eye. GMS systems, which we sell and service, fit folders, tip-on lines and conveyors. The head placement and the timing are what make a clean dot, so when a line starts missing or stringing, those are the first things we check.

Maintenance that prevents the two common failures

Char. Glue that sits hot and exposed to air oxidizes and turns dark. The result is carbon in the tank, blocked filters and a nozzle that fires late or not at all. Keep the lid closed, run the temperature the glue’s data sheet calls for and not higher, and purge the system before a long idle. Change the tank and gun filters on a schedule rather than when they fail.

Stringing and missing dots. Usually a worn nozzle, a tired heater, a photo eye out of position, or glue that is not up to temperature. Nozzles, heaters and filters are consumables; we stock them.

Ordering glue

Give us the system model and what you are gluing. Fugitive and permanent glues are not interchangeable, and the pellet or chip size has to suit the tank. If you run a lot of one job, a standing order keeps a case on the shelf.

Questions we get

What is fugitive glue?

A low-tack hot melt that holds something in place, then peels off cleanly without tearing the paper. It is what holds a plastic card, a magnet or a sample to a letter. Some people call it credit card glue or removable glue.

Why is my hot melt turning dark and clogging the nozzle?

Char. Glue that sits hot in an open or overheated pot oxidizes and leaves carbon that blocks filters and nozzles. Keep the lid closed, run the temperature the glue data sheet calls for, and purge and change filters on a schedule.

Can one glue system run both fugitive and permanent glue?

Usually not without a full purge, and the two glues want different temperatures. It is simplest to dedicate a system to each.