Inkjet addressing ink: aqueous, solvent or UV, and how to match ink to your stock

By the Tri-State Equipment parts desk. Updated November 16, 2026.

Most addressing problems on a mailing base come down to one mismatch: the ink was built for a different paper. Here is how the three ink families behave, and how to pick.

In short

  • Aqueous ink for uncoated paper; solvent for coated and glossy stock; UV-cure for plastics.
  • Cartridges are simple and carry a fresh head each time; bulk ink costs less per piece at volume.
  • Match the ink to the stock first, then to the print system.
  • Most print problems on coated stock are an ink choice, not a machine fault.

Aqueous (water-based)

Dries by absorbing into the paper. It is the standard for uncoated stock: envelopes, offset paper, newsprint, most self-mailers. Clean, low odor, easy on the heads. It will not dry on a coated or glossy surface, which is where smearing and offsetting on the stack come from.

Solvent

Dries by evaporation, so it bonds to surfaces that do not absorb: coated and glossy postcards, UV-coated covers, poly bags, some film. Faster dry, more odor, and it needs the ventilation and head care the system manual calls for. A common setup is a solvent cartridge kept aside for coated jobs with aqueous for everything else.

UV-curable

Cures under a UV lamp mounted on the base rather than drying. Sticks to plastic cards, coated board and other non-porous surfaces, and the result is durable and scratch-resistant. It needs a base with a UV curing station, so this is a system decision, not just an ink decision.

Cartridges vs bulk ink

Thermal inkjet print systems take cartridges: easy to swap, good for shorter runs and variable data, and the print head is replaced every time you change the cartridge. Piezo and bulk-ink systems feed ink from a bottle to a fixed head: lower ink cost per piece on long runs, but the head needs maintenance. Kirk-Rudy bases run both kinds depending on the print system fitted, which is why our Kirk-Rudy ink page lists more than one family.

Picking the ink

  1. Start with the stock. Uncoated: aqueous. Coated or glossy: solvent. Plastic or synthetic: UV-cure, on a base that has the lamp.
  2. Then the print system. Cartridge or bulk, and the exact model.
  3. Then the run. Long runs favor bulk ink; short and frequent runs favor cartridges.
  4. Test on the real stock before the job. Print a hundred pieces, stack them, and check for offset after ten minutes.

Keeping heads happy

Cap cartridges when the base sits idle. Wipe heads with the lint-free material the manual specifies, never a shop rag. Keep ink sealed and at room temperature, and use the oldest box first. If print quality drops on a known-good ink, the head or the stock usually changed, not the ink.

When you order, give us the print system model, the ink you run today and the stock you are moving to. We will match it, and we will tell you if what you are asking for will not dry on that paper.

Questions we get

Why does my address smear on glossy postcards?

Water-based (aqueous) ink dries by soaking into the paper. Coated and glossy stock will not absorb it, so it sits on the surface. Switch to a solvent-based ink made for coated stock, or add a dryer to the base.

Can I run any ink in my cartridge printer?

No. Cartridges are built for a specific ink chemistry and print system. Tell us the print system model and the stock you run and we will match the cartridge.

How long does inkjet ink last on the shelf?

Sealed and at room temperature, most inks and cartridges keep for many months. Opened cartridges dry out faster. Check the date on the box and rotate stock, oldest first.