Machine down? What to tell us so the right fix arrives first

By the Tri-State Equipment parts desk. Updated November 16, 2026.

When a machine stops in the middle of a job, the fastest repair is the one that is half diagnosed before anyone gets in a van. Five minutes on the steps below usually means one visit with the right parts instead of two, and often no visit at all.

In short

  • Check power, air, the e-stop and the obvious jam first.
  • Think about what changed right before it started.
  • Send a short video of the problem and a photo of the serial plate.
  • Tell us how down you are: stopped, slow, or working around it.

Before you call: four quick checks

  1. Power. The machine has power at the outlet and the main switch is on.
  2. Air. If it uses compressed air, the air is on and at pressure.
  3. Emergency stop. Released, and any safety interlock or cover closed.
  4. The obvious jam. Clear any product caught in the feeder, transport or head area, with the machine powered down.

Then think about the last change: a new job, new stock, a new roll, a moved sensor, a software update. That one detail solves a surprising number of calls.

What to tell us

Tell us Example
Make, model and serial number A photo of the serial plate, usually on the frame near the operator side
What it is doing Feeding doubles, tab landing off the edge, white lines in the print, strapper not tensioning
When it happens Every piece, every few hundred, only at speed, only on one job or stock
Any message on the screen A photo of the display
What you already tried So we do not ask you to repeat it
How urgent it is Stopped completely, running slow, or running with a workaround

Send a short video

A 15 to 30 second phone video of the problem happening is the single most useful thing you can send. Hold the phone steady on the spot where it goes wrong and run a few pieces through. Text it to 914.668.8119, or attach it to the request form on the service page.

What not to do

  • Do not remove parts or loosen adjustments to “see what happens.”
  • Do not keep running a machine that is making a new grinding or knocking noise.
  • Do not swap in cleaners or fluids the manual does not call for.

Phone and screen share first

Many problems never need a visit: software and data issues on inkjet systems, settings, sensor teaching, and many adjustments. Our technicians handle those by phone and screen share, anywhere in the US and Canada. When the fix does need hands on the machine, the call still pays off, because the technician arrives knowing what to bring.

When a visit is needed

On-site service covers New York, New Jersey, Connecticut, Pennsylvania and Delaware. We respond within one business day and schedule the visit; if you are down, tell us, and depending on the need we will work to move you up the schedule. Have the area around the machine clear, the product you were running on hand, and someone who saw the problem available, and the visit will be shorter.

After the fix

Ask the technician what caused it and which wear parts are close to their limit. Ordering those now, before they fail on deadline, is the least expensive service call there is.

Questions we get

How fast will a technician come out?

We respond within one business day. On-site visits are scheduled; if your production is down, tell us, and depending on the need we will work to move you up the schedule.

Can you fix it without a visit?

Often. Software, data, settings and many adjustment problems are solved by phone and screen share, anywhere in the US and Canada.

What is the most useful thing to send?

A 15 to 30 second phone video of the machine doing the wrong thing, plus a photo of the serial plate. Those two tell a technician more than a long description.

Should I try to take it apart first?

No. Clear jams and check power and air, but do not remove parts or loosen adjustments. A machine that has been taken apart is slower to diagnose.