Strapping basics: polypropylene vs polyester vs steel, and which strapper to run

By the Tri-State Equipment parts desk. Updated November 16, 2026.

Strapping is the last thing to touch a mail tray or a carton before it leaves, and it is usually ordered in a hurry. Three materials cover nearly every job.

In short

  • Polypropylene for mail trays, bundles and cartons; polyester for pallets and heavy, rigid loads; steel for the extremes.
  • Strap has to match the machine: width, thickness and core size.
  • Automatic arch strappers for production lines, tabletop units for lower volume, battery hand tools for pallets.
  • Most strapper problems trace back to the wrong strap, lint in the arch, or a dirty or worn heater at the weld.

Polypropylene (PP)

The workhorse for mail shops and light packaging. Inexpensive, light, a little stretchy, and the standard feed for automatic arch strappers and tabletop machines. Right for mail trays and tubs, bundled flats, newspaper and catalog bundles, and cartons of ordinary weight. It relaxes over time, so it is not the strap for a pallet that will sit in a warehouse.

Polyester (PET)

Higher break strength and it keeps its tension, so it is the strap for pallets, rigid loads, bricks and lumber, and anything that will be handled, stacked or shipped a long way. It is the usual replacement for steel strap where the load does not need steel. Needs a strapper or tool rated for PET.

Steel

The strongest and the sharpest. For heavy or hot loads, steel coils, and loads with sharp corners that would cut plastic strap. More expensive, harder to handle, and it rusts.

Matching strap to the machine

Strap is specified by width, thickness and core size, and a strapper is built around one range. The common machine widths run from about 5 mm (3/16 in) up to 12 to 15 mm (1/2 to 5/8 in). A roll that is slightly off in width or core will feed badly, jam in the arch, or weld poorly. Order by the machine model: we keep the strap for the EAM-Mosca and Berran strappers our customers run.

Which strapper

  • Automatic arch strapper. The piece goes through the arch, the strap feeds, tensions and welds without an operator touching strap. For any line doing volume: mail trays, cartons on a conveyor.
  • Semi-automatic tabletop. The operator feeds the strap end into the machine and it tensions and seals. For lower volume or odd-shaped loads.
  • Battery hand tool. For pallets and anything too big for an arch. Tensions and friction-welds plastic strap in one motion.

Keeping it running

Keep the strap dry and off the floor. Dust and paper lint in the arch is the most common cause of mis-feeds; blow it out on a schedule. Watch the weld: a strap that pulls apart at the seal usually means the heater is dirty or worn, a part we stock. If a strapper is down and the trucks are waiting, call the service line and say the machine is down; we will work to move you up the schedule.

Questions we get

What strapping do I use for mail trays and bundles?

Polypropylene. It is light, inexpensive, and it is what automatic arch strappers in mail shops are set up to run.

What is the difference between polypropylene and polyester strap?

Polypropylene stretches and loses some tension over time, which is fine for bundles and cartons. Polyester holds its tension and has much higher break strength, so it is the choice for pallets and heavy, rigid loads.

Will any roll of strap fit my strapper?

No. Machine strap is matched to the machine by width, thickness and core. Order by the strapper model and we will send the right roll.