Wafer seals and tabs: sizes, perf or no perf, and what USPS requires
A wafer seal (a tab) is the round adhesive seal a tabber applies to hold a folded self-mailer, booklet or double postcard closed, so the piece can run through USPS automation without the open edge catching. USPS requires it: an unenveloped letter-size piece mailed at machinable or automation prices has to be sealed along its open edges with tabs, glue or tape. The rules are short, but they trip people up every election season.
In short
- Use non-perforated tabs on folded self-mailers and booklets mailed at automation prices.
- 1 inch and 1-1/2 inch are the sizes that matter; booklets require 1-1/2 inch.
- Keep tabs off the barcode, postage and address; use a paper tab anywhere one could land in the barcode clear zone.
- The exact tab count for each design is in USPS DMM 201.3.14, and extra tabs are always allowed.
The three things to get right
Size. 1 inch and 1-1/2 inch are the two sizes that matter. USPS requires 1-1/2 inch non-perforated tabs on letter-size booklets, and recommends 2 inch paper tabs for large, heavy booklets. Folded self-mailers and double postcards are usually tabbed with 1 inch or 1-1/2 inch seals depending on the design. Most Kirk-Rudy tabbers can run either size; if you switch, ask us about the changeover parts.
Material. Clear, translucent (frosted) and white paper are the common choices. Clear and translucent disappear on the piece. Paper tabs matter in one place: a tab that lands in the barcode clear zone must have a paper face that meets USPS reflectance standards, so the barcode reads. Keep tabs away from the barcode, postage and address block whenever the design allows.
Perforated or not. USPS does not accept perforated tabs on folded self-mailers or booklets at automation prices, because perforations fail in high-speed processing. Non-perforated (“no perf”) seals are the default. V-perf seals, which tear open with a thumb, still have a place on pieces that are not mailed under those standards, such as hand-delivered or enveloped work.
How many tabs, and where
USPS sets the count by the paper’s basis weight and where the folded edge sits. The patterns to know:
- Double postcards: 75 lb book-grade minimum, folded edge at top or bottom, one tab in the middle of the open edge.
- Booklets: 1-1/2 inch non-perforated tabs, glue, or 1-1/2 inch tape along the open edges.
- Folded self-mailers: two or three tabs on most single-sheet designs; heavier stock and a folded edge on the right or left side push the count up.
The authoritative table is USPS DMM section 201.3.14, with piece exhibits on PostalPro. In every case USPS allows more tabs than the minimum, so when in doubt add one. Tabs, glue or tape must never cover the barcode, postage or address.
Ordering the right roll
Tabs come on rolls from 5,000 to 40,000 seals depending on size, several rolls to a box. The roll has to match the tabber’s core and the seal size. When you order from us, give us the tabber model, the seal size and whether you need perf or no perf, and we will match the roll. Standing orders on tabs are the easiest way to never run out mid-job; ask Joe at the parts desk.
Before a big mailing
Run twenty pieces through the tabber on the actual stock. Check that seals land where the design calls for them, that none touch the barcode clear zone, and that the fold is tight enough that the seal holds. If a USPS acceptance clerk flags a piece, the tab count and placement are the first things they look at.
Questions we get
How many tabs does a folded self-mailer need?
It depends on the paper weight and where the folded edge sits. Most single-sheet designs run two or three tabs. The count for each design is in USPS DMM 201.3.14, and extra tabs are always allowed.
Can I use perforated wafer seals on a self-mailer?
Not for folded self-mailers or booklets mailed at automation prices. USPS requires non-perforated tabs on those. Perforated tabs are for pieces that do not have to meet the automation sealing standard.
What size wafer seal do I need?
1 inch and 1-1/2 inch cover almost everything. Booklets must use 1-1/2 inch tabs. If you are unsure, tell us the piece and the tabber model and we will tell you which roll fits.